Buy Now
JConcepts now offers 3D printed wire route sleeve directly through Shapeways. The unique and small design of the wire sleeve pieces allow wiring to look clean and also aides in the overall appearance of your vehicle.
The 3-wire route is made to bring the A,B and C wires in close together so they look in style and constantly in flow. The 3-wire sleeve holds the wires in a clean position and minimizes the height providing a little more room between body, wiring and electrical.
The 2-wire route is made to bring the positive and negative power wires in close together so they look in style and constantly in flow. The 2-wire sleeve holds the wires in a clean position and minimizes the height providing a little more room between body, wiring and electrical.
The 3-wire sleeve and motor ring is made specifically for the Team Associated B64 and brings the A,B and C wires in close to the motor without touching. The built-in ring holds the wires in a clean position and minimizes the height providing a little more room between body and wiring.
To install, it’s necessary to have clean wires disconnected from the motor or battery plugs. Simply slide on the wire route sleeve into place and then attach or solder wires back into place. The item works best with 13 gauge wire or smaller but can accommodate slightly different wire size by slightly reaming the plastic to desired size or fit. The JConcepts versions are built to fit snuggly and directly for the Reedy 510R competition ESC with 13 gauge wires.
